Haga clic aquí para español→
Book a Visit Call Text

No stream, a dribble, or steam where water should be.

Outboard Not Peeing?
Weak Or No Tell-Tale Stream?

The tell-tale is the only gauge most outboards give you for the water pump. When it stops, the impeller is usually worn, the pee hole is blocked with salt or a wasp nest, or the thermostat is stuck. In this heat, a dry impeller finishes itself off in seconds.

Book a $250 Diagnostic Visit (239) 834-8532 Text Us The Engine

What It Usually Is

No stream at all, engine runs: a worn or shredded impeller, a cracked water pump housing or wear plate, or an intake grate packed with mud or seagrass. Impellers in Southwest Florida live on sand, salt and heat; two seasons is a long life.

A weak, spitting or intermittent stream: a partly blocked tell-tale fitting, a kinked or split tell-tale hose, or an impeller that has lost a vane or two. Salt crystals build up in the small pee-hole fitting and choke it a little more every trip.

Hot stream, or steam: water is moving but not enough of it, or a thermostat is stuck. A hot tell-tale often comes right before the overheat alarm. On a four-stroke, scale in the cooling passages does the same thing slowly.

Peeing on the muffs but not in the water: the intake is drawing air at the surface, the engine is trimmed too high, or the lower-unit intake grates are blocked. On the water the pump has to lift; on the hose it is pushed.

What To Check Safely

The pee hole — poke it gently with a piece of trimmer line or a paper clip with the engine off; salt and insects block it constantly
Trim — lower the engine so the intake grates are well under water, then look again
The grates — look for grass, mud or a plastic bag on the lower-unit intakes
The hose — with the cowl off, follow the small tell-tale hose for a kink, a split or a loose end
Temperature — feel the cowl and the water stream: warm is normal, too hot to hold is not
The impeller's age — if nobody can say when it was changed, it is due

Do not run the engine dry for even a few seconds to test; a dry impeller can shred in that time. Use muffs and a hose, or test it in the water.

When To Stop And Call

If there is no stream and the engine is getting hot, shut it down and do not restart it to check. An outboard with no cooling water overheats in minutes. Heads warp, head gaskets fail and powerheads score, and those repairs cost many times what an impeller does. Shut it down, get a tow if you have to, and text us the engine. We bring the water pump kit to the boat.

Water Pump And Impeller Service At Your Dock: Yamaha, Mercury, Suzuki

We confirm what the pump is actually doing, not just what the tell-tale shows: flow at the pee hole, pressure at the pump, the thermostat, and the tell-tale circuit itself. If the impeller is due we drop the lower unit at the dock and install the full water pump kit, impeller, housing, wear plate, gaskets and seals, for Yamaha, Mercury and Suzuki, then verify the stream and the running temperature on the water.

Regular hours (6am–4pm): a $250 diagnostic visit. We come to the boat, find the actual cause, and quote parts and labor before any work starts. After hours, Sundays and holidays: a $295 call-out. Parts, labor and sales tax always show as separate lines on the invoice, so you can see exactly what you paid for.

Want the whole engine looked after, not only this fault? See the Premium Full Service — the complete outboard service, whatever your hour meter says, parts included and one price per engine, and Dock Care for boats that sit between trips.

Service guides: Yamaha oil change · Mercury & Verado oil change · Lower unit service · Fuel filters · The 100 / 300 / 500-hour service explained · Electrical & electronics problems.

Straight Answers

Is it bad to run the engine briefly if it is not peeing?
Yes. The impeller is rubber and the water is what lubricates it. Even twenty seconds dry can tear the vanes, and the engine starts overheating within a couple of minutes. Find out why before you run it again.

My outboard pees but still overheats. Why?
The tell-tale only shows that some water is leaving the engine. A weak pump, a thermostat stuck shut, a blocked passage or a failed poppet valve can all let a stream out while the powerhead runs hot. We check flow and temperature together.

How often should the impeller be changed in Southwest Florida?
Every year or every 100 hours on a boat that runs in sand and salt, which is most of them here. It is part of the complete outboard service we do at the dock.

Can you change a water pump impeller at my dock or lift?
Yes. We drop the lower unit on the lift or at the dock, install the kit, and run the engine to confirm the stream. Most impeller jobs are done in one visit.

Do you come to Fort Myers Beach, Sanibel or Cape Coral for an outboard that is not peeing?
Yes. Back-bay docks on Fort Myers Beach, lifts on Sanibel and Captiva, every Gulf-access canal in Cape Coral, Pine Island, Bonita, Naples and Marco Island. We bring the water pump kit for your engine.

What if the lower unit has never been off?
Then it may be seized to the driveshaft with corrosion. We work it off carefully at the dock; if it fights, we tell you before we go further. That is exactly why impellers should not be skipped for years.

Anywhere The Boat Is

Dock, lift, marina, driveway or storage lot — we come to the boat across Southwest Florida:

The tell-tale quits in the same places every season: skiffs that run the flats of Pine Island Sound and Matlacha Pass with the grates in the sand, back-bay boats on Fort Myers Beach and San Carlos Island, lifts on Sanibel and Captiva, the Gulf-access canals of Cape Coral, and canal homes from Bonita Springs to Naples and Marco Island. Boca Grande and Punta Gorda too. We come to the boat with the water pump kit for your engine.

Cape CoralFort MyersNorth Fort MyersLehigh AcresFort Myers BeachSanibel & CaptivaPine Island & MatlachaPunta GordaPort CharlotteBoca GrandeBonita SpringsEsteroNaplesMarco IslandLaBelle & Alva

No Stream? Get The Pump Looked At Before The Next Trip.

Text us the engine model and where the boat sits. We carry water pump and impeller kits for Yamaha, Mercury and Suzuki and usually do the job at the dock the same day.

Book a $250 Diagnostic Visit (239) 834-8532 Text Us

Se habla Español · All services →

More boat problems: Boat won't start · Overheating alarm · Lower unit leaking · Won't go into gear · Trim not working · Battery keeps dying · What repairs cost · GPS or chartplotter dead · Boat lights not working · Bilge pump not working · Livewell pump not working · Gauges not working · Outboard alarm going off · Losing power, won't plane · Stalls at idle or in gear · Not charging the battery · Steering stiff or leaking · Prop vibration or spun hub · Water in the fuel · Outboard smoking · Jack plate not working · Power-Pole & trolling motor · Garmin & electronics installs · Emergency, open now · Yamaha outboard repair · Mercury & Verado repair · Suzuki outboard repair