Sputters, stalls, and a filter bowl that looks like milk.
Ethanol gasoline pulls water out of humid air, and Southwest Florida air is nothing but humid. The water settles to the bottom of the tank, which is exactly where the fuel pickup lives. The engine drinks it first thing after a week at the dock.
Sputtering, surging or stalling, especially after sitting: water in the tank reaching the engine. The water-separating filter catches the first of it and then fills up; after that the engine gets a slug of water with every tank movement.
Hard starting and a water-in-fuel alarm: the sensor in the engine's fuel filter bowl is doing its job. Drain the bowl and you will see a clear layer under the fuel. The question is how much more is in the tank.
Primer bulb will not firm up, or collapses: an anti-siphon valve stuck closed, a cracked or sucking fuel line, a clogged pickup screen, or a failed low-pressure fuel pump. Air gets in or fuel cannot get out.
Fuel smell in the bilge or at the deck fill: a cracked fill hose, a failed sending-unit gasket, or a tank fitting weeping. A fuel leak is a safety issue first and a fuel-system problem second.
Phase separation after months of sitting: the ethanol and water have dropped out of the gasoline as a separate layer that will not burn. No additive fixes that; the tank has to be pumped and the fuel system cleaned.
Never run a boat with a fuel smell in the bilge. Ventilate it, find the source and fix it before the key is turned.
If the engine stalls repeatedly and the filter bowl shows water every time you drain it, stop treating the symptom. Changing filters over and over while the tank is full of water just moves the water into the engine. Water reaches the injectors and the VST, and corrosion starts. We come to the dock, measure what is in the tank and deal with the tank, not only the filter.
We test the fuel, drain and inspect the separator and the engine filters, check the lines, bulb, anti-siphon valve and vent, and measure what is in the tank. A little water gets drained and filtered out; a lot gets pumped out and the system cleaned before new fuel goes in. VST service, injector cleaning and fuel pumps are quoted in writing. You get fuel that burns, and the reason it went bad.
Regular hours (6am–4pm): a $250 diagnostic visit. We come to the boat, find the actual cause, and quote parts and labor before any work starts. After hours, Sundays and holidays: a $295 call-out. Parts, labor and sales tax always show as separate lines on the invoice, so you can see exactly what you paid for.
Want the whole engine looked after, not only this fault? See the Premium Full Service — the complete outboard service, whatever your hour meter says, parts included and one price per engine, and Dock Care for boats that sit between trips.
Service guides: Yamaha oil change · Mercury & Verado oil change · Lower unit service · Fuel filters · The 100 / 300 / 500-hour service explained · Electrical & electronics problems.
Can I just add a fuel treatment and run it out?
For a small amount of free water, a quality treatment and fresh filters can get you through. For phase-separated fuel, no. That layer will not burn and no additive puts it back together. It has to come out.
How does water get into a boat fuel tank?
Humid air through the vent every day, condensation on a half-empty tank, a bad fill cap gasket, or a fuel dock with water in its own tanks. Ethanol fuel then holds that water until it cannot, and drops it out.
How much fuel can you pump out at the dock?
We arrange tank pump-out and fuel polishing for the amount in the boat and quote it before anything starts. Small tanks are handled directly; large tanks are set up with the right equipment and disposal.
Will water in the fuel damage my outboard?
It can. Water in the injectors and the VST corrodes them and causes misfires. Caught early, it is filters and a drain. Caught late, it is injectors and a pump.
Do you come to Boca Grande, Pine Island or Fort Myers Beach for fuel problems?
Yes. Boats that stage for Boca Grande Pass, skiffs out of Bokeelia and St. James City, back-bay boats on Fort Myers Beach, Sanibel and Captiva, Cape Coral, Bonita, Naples, Marco Island and Punta Gorda.
How often should the water-separating filter be changed here?
Every 100 hours or once a season, and more often on a boat that sits. It is part of the complete outboard service we do at the dock, and it is cheap insurance.
Dock, lift, marina, driveway or storage lot — we come to the boat across Southwest Florida:
Fuel goes bad fastest on boats that wait between trips: seasonal owners' boats on lifts in Naples, Bonita Bay and Marco Island, racks on Fort Myers Beach, canal boats in Cape Coral and Punta Gorda Isles, lifts on Sanibel and Captiva, and the fishing fleet out of Pine Island and Boca Grande. We come to the boat and sort the tank where it sits.
Text us the engine and what you found in the bowl. We bring filters, bulbs, lines and the tools to measure what is in the tank for Yamaha, Mercury and Suzuki boats.
Se habla Español · All services →
More boat problems: Boat won't start · Overheating alarm · Lower unit leaking · Won't go into gear · Trim not working · Battery keeps dying · What repairs cost · GPS or chartplotter dead · Boat lights not working · Bilge pump not working · Livewell pump not working · Gauges not working · Outboard not peeing · Outboard alarm going off · Losing power, won't plane · Stalls at idle or in gear · Not charging the battery · Steering stiff or leaking · Prop vibration or spun hub · Outboard smoking · Jack plate not working · Power-Pole & trolling motor · Garmin & electronics installs · Emergency, open now · Yamaha outboard repair · Mercury & Verado repair · Suzuki outboard repair